Put Your Collar to Sleep During Travel (Using Travel Mode)

You may want to take SkyShepherd from one place to another. To save battery while travelling, you can put your SkyShepherd in a low-power state. 

NOTE: De-activate any boundary active on the collar before entering turning Travel Mode on and taking SkyShepherd to another location. Otherwise, when you turn Travel Mode off, and after your GPS collar unit gets good enough signal, the boundary you had active before may reactivate and the collar will detect itself as out of bounds and may give unwanted feedback.

When you get where you're going, you can slide the "Travel Mode" toggle to the left, off. The collar will make a powering-up sound, and when the GPS and gateway signals come back, your device is back in normal mode. A word of note, it may take a few minutes for GPS signal to fully recover from Travel Mode. You might have to wait until you can activate a boundary. Additionally, if you are in a building you may not see GPS signal, even though it has turned back on. Go outside and find some open sky to speed up the GPS signal acquisition process.